SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 83)

Advanced Configuration
6-7
TCP / IP Settings
Configuring the wireless bridge with an IP address expands your
ability to manage the wireless bridge. A number of wireless
bridge features depend on IP addressing to operate.
Note: You can use the web browser interface to access IP addressing
only if the wireless bridge already has an IP address that is
reachable through your network.
By default, the wireless bridge will be automatically configured
with IP settings from a Dynamic Host Configuration Protocol
(DHCP) server. However, if you are not using a DHCP server to
configure IP addressing, use the CLI to manually configure the
initial IP values (page 5-2). After you have network access to the
wireless bridge, you can use the web browser interface to modify
the initial IP configuration, if needed.
Note: If there is no DHCP server on your network, or DHCP fails, the
wireless bridge will automatically start up with a default IP address
of 192.168.2.2.