SMC Networks ElliteConnect 2.4GHz/5GHz - Manual (Page 82)

System Configuration
6-6
CLI Commands for System Identification – Enter the global
configuration mode and use the system name command to
specify a new system name. Use the snmp-server location and
snmp-server contact commands to indicate the physical
location of the wireless bridge and define a system contact. Then
return to the Exec mode, and use the show system command to
display the changes to the system identification settings.
CLI Commands for Bridge Band Selection – Enter the global
configuration mode and use the wds channel command to
specify the bridge band.
AP#configure 7-10
AP(config)#system name R&D 7-19
AP(config)#snmp-server location building-1 7-38
AP(config)#snmp-server contact Paul 7-35
AP(config)#exit
AP#show system
7-22
System Information
===================================================
Serial Number : 0000000005
System Up time : 0 days, 0 hours, 35 minutes, 56 seconds
System Name : R&D
System Location : building-1
System Contact : Paul
System Country Code : US - UNITED STATES
MAC Address : 00-30-F1-BE-F4-96
IP Address : 192.168.2.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
VLAN State : DISABLED
Native VLAN ID : 1
IAPP State : ENABLED
DHCP Client : ENABLED
HTTP Server : ENABLED
HTTP Server Port : 80
Slot Status : Dual band(a/g)
Software Version : v1.1.0.3
===================================================
AP#
AP#configure 7-10
AP(config)#wds channel a 7-62
AP(config)#