Promise Technology VTrack M-Class M200i - Manual (Page 302)

VTrak M-Class Product Manual
294
Network Connections
VTrak has an RJ-45 Management Port connector on the back of its cabinet. This
is a Gigabit Ethernet connector designed to connect to your network. The VTrak
becomes a node on your network like any other PC, server or other component
with an IP address.
VTrak ships from the factory an IP address of 10.0.0.1. You must change this
address to one that will work with your network. You make the initial IP address
setting using the CLI or CLU. See “VTrak Setup with CLI or CLU” on page 29.
Note that VTrak Management Port can accept IP address assignments from a
DHCP server. Use VTrak's Command Line Utility (CLU) to enable this feature. If
you have not activated DHCP support but there is a DHCP server on your
network, there is a chance that it will inadvertently assign the VTrak's
Management Port IP address to another node. You might see a warning to this
effect on your PC's monitor. If this happens, WebPAM PROe may not be able to
connect. See your network administrator to work out a suitable arrangement.
LEDs
State
Dark Amber Green Flashing Green
Connectivity 10BaseT 1000BaseT 100BaseT n/a
Activity No activity n/a n/a Activity
“n/a” means this state does not apply to this LED.
Connectivity LED Activity LED