Promise Technology VTrack M-Class M200i - Manual (Page 45)

Chapter 3: Setup
37
iSCSI Ports
By default, DHCP is enabled on VTrak (above). To set iSCSI Port settings
manually, or to view the current settings, you must disable DHCP.
To view the current iSCSI Port settings:
1. Press the arrow keys to highlight DHCP.
2. Press the spacebar to toggle to Disabled.
3. Record the information on this screen.
See the illustration on the next page.
4. Press the spacebar to toggle DHCP back to Enabled.
5. Press Ctrl-A to save these settings and move to the iSCSI Port 2 screen.
6. Follow the same procedure to view settings for iSCSI Port 2.
7. Press Ctrl-A to save these settings and move to the RAID configuration
screen.