Promise Technology VTrack M-Class M200i - Manual (Page 49)

Chapter 3: Setup
41
VTrak Setup with WebPAM PROe
Set up with WebPAM PROe consists of the following:
• Log-in to WebPAM PROe (below)
• Language Selection (page 44)
• Create a Disk Array (page 45)
• Additional Logical Drives (page 54)
• Log-out of WebPAM PROe (page 54)
• Internet Connection using WebPAM PROe (page 55)
Log-in to WebPAM PROe
1. Launch your Browser.
2. In the Browser address field, type in the IP address of the VTrak
Management port.
Use the IP address you obtained in Step 7. Note that the IP address shown
below is only an example. The IP address you type into your browser will be
different.
Regular Connection
• WebPAM PROe uses an HTTP connection . . . . . . . . . . . . . . ..http://
• Enter the VTrak’s Management Port IP address . . . . 192.168.10.87
Together, your entry looks like this:
http://192.168.10.87
Secure Connection
• WebPAM PROe uses a secure HTTP connection . . . . . . . . . .https://
• Enter the VTrak’s Management Port IP address . . . . 192.168.10.87
Together, your entry looks like this:
https://192.168.10.87
Notes
• You can also use the CLU to create disk arrays and logical
drives. See “Chapter 5: Management with the CLU” on
page 157 for more information.
• The WebPAM PROe software is embedded on the VTrak M-
Class subsystem. No installation is required.