Promise Technology VTrack M-Class M200i - Manual (Page 39)

Chapter 3: Setup
31
administrator@cli> net -a mod -t mgmt -s "primaryip=192.168.10.87,
primaryipmask=255.255.255.0, gateway=192.168.10.3"
In the above example, the IP addresses and subnet mask are included as
examples only. Your values will be different.
If you prefer to let your DHCP server assign the IP address, type the
following string, then press Enter.
administrator@cli> net -a mod -t mgmt -s "dhcp=enable"
3. To verify the settings, type net, and press Enter.
administrator@cli> net
===========================================
CId Port Type
IP Mask Gateway Link
===========================================
1 1
Mgmt 192.168.10.87 255.255.255.0 192.168.10.3 Up
1 1 iSCSI 0.0.0.0 0.0.0.0 0.0.0.0 Down
1 2 iSCSI 0.0.0.0 0.0.0.0 0.0.0.0 Down
4. Type the following string to set the iSCSI Port IP address and other settings,
then press Enter.
administrator@cli> net -a mod -t iSCSI -p 1 -s
"primaryip=192.168.10.88, primaryipmask=255.255.255.0,
gateway=192.168.10.3"
If you prefer to let your DHCP server assign the IP address, type the
following string, then press Enter.
administrator@cli> net -a mod -t iSCSI -p 1 -s "dhcp=enable"
5. To verify the settings, type net, and press Enter.
administrator@cli> net
===========================================
CId Port Type
IP Mask Gateway Link
===========================================
1 1
Mgmt 192.168.10.87 255.255.255.0 192.168.10.3 Up
1 1 iSCSI 192.168.10.88 255.255.255.0 192.168.10.3 Up
1 2 iSCSI 0.0.0.0 0.0.0.0 0.0.0.0 Down
6. Repeat steps 3 and 4 to set the other iSCSI port. Use -p 2 in place of -p 1.
This completes the Management and iSCSI port setup. Go to “Install iSCSI
Initiator on the Host PC” on page 39.
To see the full set of CLI commands, at the admin@cli> prompt, type help, and
press Enter.