Nortel Networks NN43001-121 - Manual (Page 182)

182 Configuration
Figure 66
SIP CTI Services settings
Parameter: Service Enabled
The default state of the SIP CTI service is disabled. To enforce the change
of state for this parameter, you must reboot. The SIP CTI service consumes
approximately 140 MB of RAM on the Signaling Server when enabled.
ATTENTION
The configuration change to enable or disable the SIP CTI service is propagated
to all Signaling Servers within the node. Ensure that engineering guidelines are
considered for all Signaling Servers within the node before you enable this feature.
Parameter: Customer Number
The customer number parameter defines the customer on the Call Server
to which SIP CTI service requests apply. Each TR/87 FE can support
one customer number. Additional customers can be supported by adding
additional Signaling Servers.
Nortel Communication Server 1000
Nortel Converged Office Fundamentals — Microsoft Office Communications Server 2007
NN43001-121 01.03 Standard
Release 5.0 30 April 2008
Copyright © 2005–2008, Nortel Networks
.