Ricoh 700 - Manual (Page 104)

Copying
88
2
Other Functions
Energy Saver Mode
If you do not operate the machine for a certain period after copying, or when you
press and hold the {
Clear Modes/Energy Saver } key for more than one second, the
display disappears and the machine enters Energy Saver mode. When you press
the {
Clear Modes/Energy Saver } key again, when the originals are set in the docu-
ment feeder, or when the document feeder is opened, the machine returns to the
ready condition. In Energy Saver mode, the machine uses less electricity.
Energy Saver mode makes a two-step reduction in electricity: one for the period
up to the time set for Low Power mode, the other for the period after that time.
Note
❒ If you press the { Clear Modes/Energy Saver } key during the operation, the cur-
rent settings will be cleared.
❒ It takes about 10 seconds to return to the ready condition from Energy Saver
mode.
❒ It takes about 30 seconds to return to the ready condition from Low Power
mode.
❒ If you press the { Clear Modes/Energy Saver } key while setting Connect Copy,
Connect Copy mode is canceled and the machine returns to the initial condi-
tion of Copy mode.
❒ If you press the [Connect] key on the master unit, the sub-unit exits Energy
Saver mode and enters Connect Copy mode.
❒ In Connect Copy mode, the sub-unit will not enter Energy Saver mode.
Reference
See “Low Power Timer” in the System Settings manual.
Interrupt Copy
Use this function if you wish to interrupt a long copy job to make urgently need-
ed copies.
Note
❒ The procedure for making interrupt copies depends on which kind of opera-
tion the machine is currently carrying out.
❒ You can use Document Server mode in Interrupt Copy mode.
❒ In Connect Copy mode, you cannot use the Interrupt Copy function on the
master unit.
❒ In Connect Copy mode, you cannot use the Interrupt Copy function on the
sub-unit while the master unit is scanning an original.