Ricoh 700 - Manual (Page 105)

Other Functions
89
2
❒ In Connect Copy mode, you cannot use the Interrupt Copy function when
memory on the sub-unit is full.
❒ In Connect Copy mode, after finishing the interrupt copy job on the sub-unit,
be sure to exit Interrupt mode on the sub-unit. When you exit Interrupt mode,
the two machines automatically share the rest of the connect copy job.
❒ In Connect Copy mode, if the connect copy job is finished before finishing the
interrupt copy job on the sub-unit, be sure to exit Interrupt mode on the sub-
unit. If you do not exit Interrupt mode, the next connect copy job cannot be
started.
To interrupt an original being fed
A
Press the { Interrupt } key.
The Interrupt indicator goes on and scanning stops.
B
Remove the originals that were being copied and set the originals you wish
to copy.
C
Press the { Start } key.
The machine starts making your copies.
D
When your copy job is finished, remove your originals and copies.
E
Press the { Interrupt } key again.
The Interrupt indicator goes off.
F
When the display prompts you to, replace the originals that were being
copied before.
G
Press the { Start } key.
The previous copy job settings will be restored and the machine will continue
copying from where it left off.
To interrupt copying after all originals have been fed
A
Press the { Interrupt } key.
The Interrupt indicator goes on.
Note
❒ Copying will not stop yet.
B
Set your original.
C
Press the { Start } key.
The machine stops the original job and starts copying your original.