Ricoh 700 - Manual (Page 94)

Copying
78
2
Programs
You can store frequently used copy job settings in machine memory, and recall
them for future use.
Limitation
❒ You cannot store the settings whether the Connect Copy function will be se-
lected automatically in a program.
❖ Storing Your Settings
You can store your settings you frequently use.
❖ Deleting A Program
You can delete a stored program.
❖ Recalling A Program
You can recall a stored program.
Note
❒ You can store up to ten programs.
❒ You can select the standard mode or program No. 10 as the mode to be set
when modes are cleared or reset is made, or immediately after the operation
switch is turned on. See “Initial Mode” in
⇒
P.313 “General Features 2 /
3
” .
❒ Paper settings are stored based on paper size. So if you place more than one
paper tray of the same size, the paper tray prioritized with the User Tools
(System Settings) will be selected first. See “Paper Tray Priority” in the Sys-
tem Settings manual.
❒ Programs are not cleared by turning the power off or by pressing the { Clear
Modes/Energy Saver } key. They are canceled only when you delete or overwrite
them with another program.
❒ If your program contains settings that are not available in Connect Copy
mode, they are ignored in Connect Copy mode.
❒ If your program contains settings that are not available on the sub-unit, they
are ignored in Connect Copy mode.
Storing a Program
A
Edit the copy settings so that all functions you want to store in this program
are selected.