Ricoh 700 - Manual (Page 41)

Copy Paper
25
1
Important
❒ If you use damp or curled paper, a misfeed might occur. In this case, try turn-
ing over the paper stack in the paper tray. If there is no improvement, change
to copy paper with less curl.
Note
❒ When you use the bypass tray, be sure to set the copy paper direction to L.
❒ Postcards should be fed from the bypass tray.
❒ If you load paper of the same size and in the same direction in two or more
trays, the machine automatically shifts to another tray when the tray in use
runs out of paper. This function is called “Auto Tray Switching”. (If you put
recycled paper, translucent paper, user color paper 1, or user color paper 2 in
paper trays with “Special Paper Indication”, this function is not available to
these trays unless their settings are identical.) This saves interrupting a copy
run to replenish paper even when you make a large number of copies. You
can cancel this setting. See “Auto Paper Select” in
⇒
P.43 “Selecting Copy Pa-
per” , “Auto Tray Switching” and “Special Paper Indication” in the System
Settings manual.
❒ If you select Thick Paper mode or Tab Stock mode, copying speed might be
reduced.
Non-recommended Paper
R CAUTION:
Important
❒ Do not use any of the following kinds of paper or a fault might occur.
• Thermal fax paper
• Art paper
• Aluminum foil
• Carbon paper
• Conductive paper
• Colored OHP transparencies
• Paper with perforated lines
• Hemmed paper
❒ Do not use copy paper that has been already copied on. Otherwise, a paper
misfeed might occur.
• Do not use aluminum foil, carbon paper, or similar conductive paper to avoid
a fire or equipment failure.