Ricoh 700 - Manual (Page 248)

Connect Copy (Option)
232
4
Note
❒ Any copy settings that were set up before you entered Connect Copy mode
will still remain in effect. However, if optional finishers are not installed on
both the master unit and sub-unit, the Stack, Staple and Punch functions
will be automatically disabled.
❒ To exit Connect Copy mode, press the [Connect] key on the master unit
again.
Reference
For more information on functions you can use with Connect Copy, see
⇒
P.13 “Function List Based on Options”.
E
Enter the number of copies you require using the number keys.
Note
❒ You can enter up to 999 copies.
❒ If you make a mistake, press the {
Clear/Stop } key and enter a new number.
❒ Even though Connect Copy is selected, only the master unit will make cop-
ies in the following situations:
• When making a single copy set
• When the original is a single sheet and you enter a low number of cop-
ies/sets
F
Press the { Start } key on the master unit.
Copying starts after the original has been scanned.
If you set originals in the document feeder
A Copying starts simultaneously in the master unit and sub-unit after all
originals have been scanned.
If you set originals on the exposure glass
A Set the next page(s) when scanning has finished, then press {
Start } key.
B When all pages have been scanned in, press the {
# } key. Copying starts
simultaneously in the master unit and sub-unit.
Sample Copy
Clear/Stop
Start
Enter
TSPS020N