Ricoh 700 - Manual (Page 268)

What to Do If Something Goes Wrong
252
5
Connect Copy
Machine Status Problem/Cause Action
The [Connect] key does not
appear on the display.
The main power switch on
the sub-unit is off. Turn on the sub-unit main
power switch.
The operation switch on
the sub-unit is off. Press the operation switch
on the right side of the con-
trol panel. The On indica-
tor will goes on.
Note
❒ The machine will be
ready to operate about
five minutes after turn-
ing power on.
The master unit is not in
Copy mode (i.e., in Docu-
ment Server mode). Press the { Copy/New Job }
key on the master unit to
switch to Copy mode.
The master unit is in Inter-
rupt mode. Press the { Interrupt } key on
the master unit to exit In-
terrupt mode.
The master unit is in Job
Preset mode. Exit Job Preset mode in one
of the following ways.
❖ If you are still selecting
copy settings and copy-
ing has not started yet:
Press the [Cancel] key
then remove the origi-
nals set in the master
unit document feeder.
❖ If Job Preset mode is in
progress:
Press the { Clear/Stop }
key, follow the instruc-
tions on the display
then press the
[Cancel]
key.
Reference
See
⇒
P.83 “Job Preset”.