Toshiba Strata DK8 - Manual (Page 103)

5-33
INSTALLATION-DK 16 KSU & PCB
SECTION 100-816-205
MARCH 1993
TABLE 5-H
KCDU CONTROLS, INDICATORS, AND CONNECTORS
CONTROL/INDICATOR/
CONNECTOR
(Figure 5-21)
TYPE OF COMPONENT DESCRIPTION
CO line circuit 1
Indicator CD517
CO line circuit 2
Indicator CD617
J7 Connectors
PAD Switch SW501
PAD Switch SW601
Lights to indicate CO line circuit 1 is in
operation.
Lights to indicate CO line circuit 2 is in
operation.
Interface connector for CO line circuits,
1 and 2.
Enables 3dB signal level drop for CO line
circuit 1 (when set in PAD position).
Enables 3dB signal level drop for CO line
circuit 2 (when set in PAD position).
Red LED
Red LED
Modular connector
Two-position slide
Two-position slide
4) After installing the KCDU, gently pull the PCB
outward. If the connectors are properly mated,
a slight resistance will be felt.
13.30 KCDU Wiring
13.31 Refer to KCDU Wiring Diagram in Section
100-816-208 for wiring/interconnecting details.
13.40 KCDU Programming Overview
13.41 See the PCOU programming overview and
the PDKU overview in this chapter for KCDU pro-
gramming information. When running Program 03
for the KCDU slot(s), specify code 65 if the KCDU
does not support OCA or PDIU-DI telephones or
code 66 if the KCDU supports OCA or PDIU-DI
telephones. Do not specify code 11, 61, 62, or 64.
14 DTMF RECEIVER/ABR TONE
DETECTOR UNIT (K4RCU)
14.00 General
14.01 The K4RCU must be installed to recognize
Dual-Tone Multi-Frequency (DTMF) tones gener-
ated by a standard telephone (or any other device
connected to a standard telephone circuit) and it is
required for Direct Inward System Access (DISA)
calls. The K4RCU can only be installed in the Base
Unit. The K4RCU circuits are also used to detect
busy tone for the Automatic Busy Redial (ABR)
feature and must be installed to allow ABR to
operate.
14.10 K4RCU Configuration
14.11 The K4RCU does not have to be configured
for operation.
14.20 K4RCU Installation Procedure
14.21 Install the K4RCU in accordance with the
following steps (Figure 5-22).
1) Remove the PCB from its protective packag-
ing.
2) Make sure that the power supply switch is
OFF.
3) Making sure that the component side of the
K4RCU is facing up toward the power supply,
plug the K4RCU P602A and P602B female
connectors into the P2A and P2B (K4RCU)
connectors on the motherboard.