Toshiba Strata DK8 - Manual (Page 105)

5-35
INSTALLATION-DK 16 KSU & PCB
SECTION 100-816-205
MARCH 1993
16 KCOU REMOVAL AND
REPLACEMENT
16.00 General
16.01 The KCOU comes factory-installed in the
Base Key Service Unit (Figure 5-3); if necessary,
it can be removed and replaced.
16.10 KCOU Removal
1) Make sure the Power Supply (KPSU16) DC
power switch is turned off.
2) Loosen and remove screws 1 and 2 (Figure
5-23).
3) Pull back plastic stand-off tab and pull up on
KCOU until P7 is unplugged.
4) Pull wires on P6 and remove P6 connector
from Base Unit.
16.20 KCOU Replacement
1) Make sure the Power Supply (KPSU16) DC
power switch is off.
2) Mate and connect KCOU P6 cable connector
to P6 on Base Unit motherboard so that the
red wire is aligned as shown in Figure 5-23.
3) Position KCOU as shown in Figure 5-23.
4) Mate and connect KCOU P7 to P7 on the Base
Unit motherboard.
5) Secure plastic stand-off tab and install screws
1 and 2.
6) Set SW400 ~ 475 to appropriate position. In
most cases set to the normal position (NOR);
if CO lines are connected to a PBX or are in
close proximity to the Central Office, set to the
PAD position to provide a 3 db loss in signal
level.
FIGURE 5-23
KCOU PCB
KRCU
BASE UNIT
MOTHERBOARD
SW400
SW425
SW450
SW475
J4 (CO4)
J3 (CO4)
J2 (CO4)
J1 (CO4)
PLASTIC STAND-OFF
(TAB)
SW400 FOR CO1
SW425 FOR CO2
SW450 FOR CO3
SW475 FOR CO4
SCREW (1)
SCREW (2)
P6
RED RED
P7
KCOU
P2B P2A
KCOU
SW400
PAD
NOR