Toshiba Strata DK8 - Manual (Page 315)

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-65-
NOTES:
1. [M] represents the message entered.
2. DKT = digital telephone; EKT = electronic telephone.
TABLE RM-BR
MODE 96
REMOTE CALLED STATION MESSAGING (ADD/CHANGE)
ACTION STEP DISPLAY/PRINTOUT
1 >MODE MESG Enter the Message Mode
At the >MODE prompt, enter
M E S G CR .
2 m 96 To Change or Add a New Called Station Message
3
Set the terminal keyboard to the lower case (cap lock off) and
enter
m 9 6 .
4
m96 XXX
5 Enter p (p = page command and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system messages).
6
8
To Set the Message
To Exit the Message Mode m 0
q
>MODE
Enter X X X (XXX = destination station number or destination
station group number – 30 = all DKTs/EKTs, 31 ~ 34 per system,
m96 XXX p YYY p
Set the terminal keyboard to upper case and enter message
as required (alphanumeric, 32 characters max.). New message
displays as it is entered.
Set the terminal keyboard to lower case and enter p m 0 .
Destination station: Msg LED flashes, “CALL YYYM” is
displayed on LCD.
Origination station: “SENT XXXM” is displayed on LCD.
At any time, enter m 0 p (lower case).
NOTE:
Enter “m” (lower case) anytime it is desired to start over
in this procedure.
Enter p Y Y Y (p = page command and YYY = originating
station number).
m96 XXX p YYY
m96 XXX p YYY p [M]
7 m96 XXX p YYY p [M] p
m 0
To Add the New Message [M]
Program 31).
Zero