Toshiba Strata DK8 - Manual (Page 312)

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-62-
NOTES:
1. To cancel a message set via Mode 95, use Mode 97 procedure.
2. [M] represents the message entered.
3. DKT = digital telephone; EKT = electronic telephone.
TABLE RM-BO
MODE 95
REMOTE CALLING STATION MESSAGING (ADD/REVIEW/CHANGE)
ACTION STEP DISPLAY/PRINTOUT
1 >MODE MESG Enter the Message Mode
At the >MODE prompt, enter
M E S G CR .
2 m 95 To Add Or Review a Calling Station Message
3
Set the terminal keyboard to the lower case (cap lock off) and
enter
m 9 5 .
4
m95 XXX
5
Enter p (p = page command and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system message).
6
To Change Previous Message
7
To Set the Message on DKT or EKT XXX’s LCD
To Exit the Message Mode m 0
q
> MODE
Enter X X X (XXX = station number where the message will be
set and stored).
m95 XXX p [M]
Set the terminal keyboard to upper case and change message
(alphanumeric, 32 characters max.).
Set the terminal keyboard to lower case and enter p m 0 .
At any time, enter m 0 q (lower case).
NOTE:
Enter “m” anytime it is desired to start over in this procedure.
NOTES:
1.
2.
To store system messages permanently, DKT or EKT XXX
must be the station at port 00.
After
p is entered, the previously stored message is
displayed. If there is no stored message, nothing is displayed.
m95 XXX p [M+]
m95 XXX p [M+] p
m 0
Zero