Toshiba Strata DK8 - Manual (Page 161)

INSTALLATION-PERIPHERALS
SECTION 100-816-207
MARCH 1993
7-29
•
Voice Mail Control from digital and electronic
telephone
•
System Monitoring
•
Feature Integration
7.12 A block diagram of voice mail connections is
shown in Figure 7-22. See Section 100-816-204 for
QSTU and Section 100-816-205 for PSTU, KSTU,
and PESU installation instructions.
7.13 STRATA DK8 and DK16/VP Programming
Considerations. Some features of STRATA DK8
and DK16 system programming are intended for
Toshiba VP, and are not necessarily available for
customer-supplied voice mail messaging systems.
These programming features are:
•
Answer (A) Tone. The STRATA DK8 and DK16
stations will send an answer tone to Toshiba VP
when the station answers a Toshiba VP call.
•
Disconnect (D) Tone. The STRATA DK8 and
DK16 stations will send a disconnect tone to
Toshiba VP when the station hangs up while
connected to Toshiba VP. (D-Tone is also sent to
release the Toshiba VP auto attendant port
when an outside CO line caller hangs-up and the
Central Office provides a disconnect signal, per
Program 15-0 and 15-3.)
NOTE:
1. Not all Central Offices provide the discon-
nect signal (calling party control) so this
feature will not operate in all areas.
2. Both answer and disconnect tones pro-
vide more efficient Toshiba VP port use.
Always enable these options. Both op-
tions are enabled by accessing Program
31 and setting LED 15 to ON (LEDs 16 and
17 must also be ON to allow A and D
tones), and by accessing Program 15-0
and 15-3 and enabling CO lines with ARVM
and AROH calls.
3. The AR signal of some Central Offices is
not reliable and may occur at times during
a CO line voice connection causing the
call to disconnect during a conversation. If
this occurs, disable AROH and ARVM
calls on all CO lines (Program 15-0 and
15-3).
FIGURE 7-21
PIOU/PIOUS SMDR PORT (PROGRAM 97) DATA DUMP EXAMPLE
00
01
02
03
04
05
06
81
81
81
81
81
81
81
11111111
00000000
00000000
00000000
00000000
00000000
00000000
8 1
CO LINE
NUMBERS
NOTES:
1. In this example all lines are programmed to immediately ring the station at port 00 only.
2. 0 = LED off, 1 = LED on.
CO LINE 08
PROGRAM NUMBER
STATION PORT
NUMBERS
CO LINE 01
(CO LINE)
(LEDs ON)
(LEDs OFF)