Toshiba Strata DK8 - Manual (Page 314)

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-64-
NOTES:
1. Press m at any time to start over.
2. [M] represents the message entered.
TABLE RM-BQ
MODE 94
REMOTE CALLED STATION MESSAGING (ADD/REVIEW/CHANGE)
ACTION STEP DISPLAY/PRINTOUT
1 >MODE MESG Enter the Message Mode
At the >MODE prompt, enter
M E S G CR .
2 m 94 To Add Or Review a Called Station Message
3
Set the terminal keyboard to the lower case (cap lock off) and
enter
m 9 4 .
4 Enter p Y Y Y (p = page command [lower case] and
Y Y Y = originating station number).
m94 XXX
m94 XXX p YYY
5 Enter p (p = page command [lower case] and
= 2-digit message memory location: 10 ~ 19 personal
messages and 60 ~ 99 = system messages).
After
p is entered, the previously stored message (M) is
6 To Change the Message (M+)
7 To Set Message
8 To Exit the Message Mode m 0
q
>MODE
Enter X X X (XXX = Destination station number or destination
group number [30 = all stations, 31-34 per system,
displayed. (If there is no stored message, nothing is displayed.)
m94 XXX p YYY p [M]
Set the terminal keyboard to upper case and change message
as required (alphanumeric, 32 characters max. for total message).
m94 XXX p YYY p [M+]
m94 XXX p YYY p [M+] p
m 0 Set the terminal keyboard to lower case and enter p m 0 .
Destination station: Msg LED flashes, “CALL YYYM” is
displayed.
Origination station: “SENT XXXM” is displayed.
At any time, enter m 0 q (lower case).
Program 31]).
Zero