Toshiba Strata DK8 - Manual (Page 277)

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-27-
TABLE RM-R
TYPE 2 PROGRAM PROCEDURE EXAMPLE
ACTION STEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter
P R O G CR .
2 P 30 Enter Program Number
Refer to the record sheet and enter the desired program number.
Example: Program 30, enter
3 0 , press CR .
3 P30
P30 04
Enter Port Number
Refer to the System Record Sheet and enter the desired
port number(s). Example:
0 4 .
4 P30 04# Press # button.
5 P30 04# 01 N Enter the Desired Button/LED Number
Example: Button/LED 01, enter:
0 1 .
7
(PROGRAMS: 20, 30, 31, 35, 40, 41, 43, 79, 81 ~ 89)
8
To Advance to Next Button/LED
Press
SPACE (repeat Step 6 if necessary).
9 To Exit Program/Store Data
A)
B)
C) P10
P10 ##
P
To store data, press CR .
To exit this program, press # # , then press CR .
Continue returning to Step 2 until all Type 2 programs
are completed.
6 P30 04# 01 N Y To Change Button/LED Status
Refer to the System Record Sheet and change the button/LED
status, if required (Y or N).
Example: Enter
Y .
10
11
(Note)
P30 04# 01 Y-
Button LED Number
Port Number
Program Number
To Review Button/LED Status Change
Press
CR .
Re-enter Steps 3, 4, and 5.
>MODE To Exit the Program Mode
Press
# # CR .
To Enter Another Mode,
D U M P CR (data dump)
T E S T CR (test)
M E S G CR (LCD messages)
R E P T CR (speed dial)
D
T
R
(no prompt)
NOTE:
Y = button/LED(s) "ON", N = button/LED(s) "OFF"; U = button/LED(s) "ON" some ports and "OFF" other ports.
or Port Range *
Press
LED "ON"