Toshiba Strata DK8 - Manual (Page 304)

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-54-
TABLE RM-BE
PROGRAM 52
LCR OFFICE CODE EXCEPTIONS FOR SPECIFIED AREA CODE
ACTION STEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter
P R O G CR .
2 P 52
P52
Enter Program Number 52
3 P52 10 3
Press CR .
Define Route Plan Number
Refer to the System Record Sheet and enter the
exception table number (1 ~ 8).
Example: Table 1, enter
1 .
The system will print out the currently defined route
plan number. Refer to the System Record Sheet and enter
new plan number if required. Example: Change to 3.
4 P52 11 212
P52
Define Area Code Number
Enter exception table number (1 ~ 8) defined in step 3.
The system will print out the currently defined area
code number. Refer to the System Record Sheet and enter the
new area code number if required.
Press CR .
Press CR .
5 P52 14 Display Office Codes
Enter exception table number defined in step 3.
Press SPACE to display previously selected office codes.
Continually press SPACE until all previously selected
codes have been displayed, then press CR .
6 P52 12
300-325
P52
To Add (2) or Delete (3) Office Codes
Press
CR .
Enter exception table number defined in step 3.
Refer to the System Record Sheets and enter
2
to add office codes or 3 to delete office codes.
Example: Add office codes 300-325
Enter
2 (or 3 ) 3 0 0 * 3 2 5 CR .
7 P52 ##
P
To Exit Program/Store Data
A)
B)
C)
Data was stored when CR was pressed in step 6.
Continue returning to step 3 until all data is entered
for this program.
To exit this program.
Press
# # CR .
LCR Plan No.
Action Code
Exception Table No.
Example: Change to 212, enter 2 1 2 .
Area Code
Action Code
Exception Table No.
Office Codes
Enter Action code 0 .
Enter Action code 1 .
Enter Action code 4 .