Festool VS 600 accessories - Manual (Page 16)

16
5.3
5.1
5.2
5A
4 Construction
The jointing system VS 600 consists of the following components
(Figure 1):
1.1 Base
frame
1.2 Mount for templates
1.3 Rotary knob to clamp the templates
1.4 Swivel segment for mount
1.5 Clamping lever for swivel segment
1.6 Clamping lever to adjust the height of the templates
1.7 Pressure beam for horizontal clamping of the workpieces
1.8 Pressure beam of vertical clamping of the workpieces
5 Preparation
5.1
Setting up the base frame
The base frame must be fastened to a non-slip fi rm base:
• Set the base frame up so that the front edge protrudes by ap-
prox. 5 mm.
• Fasten the base frame on both sides of the base with two screws
(Figure 2) or two screw clamps (Figure 3).
5.3 Router
Note: Handling of the router (adjusting the routing depth, changing
tools, etc.) is described in its operating instructions.
Mount the required copying ring centrally in the routing plate
of the router:
• Unplug the tool from the mains.
• Turn the router upside down.
• Open the two screws (4.1) and remove the ring (4.2).
• Clamp the centring mandrel (4.4) tight in the cutter spindle.
• Place the copying ring (4.5, 5.3) into the router’s routing plate
with the collar uppermost.
• Slowly move the routing plate towards the centring mandrel
until the centring ring (5.3) is centred by the centring mandrel
(5.2).
• Screw the copying ring tight with the two enclosed screws (4.3,
5.1).
• Remove the centring mandrel from the cutter spindle.
5.4
CAUTION
Damage to the cutter and routing template
- If fi tted, remove the height-adjustable support (5.4) from the
router.