Rainbow Electronics AT91CAP9S250A - Manual (Page 717)

717
6264A–CAP–21-May-07
AT91CAP9S500A/AT91CAP9S250A
39.8.5 CAN Status Register
Name: CAN_SR
Access Type: Read-only
• MBx: Mailbox x Event
0 = No event occurred on Mailbox x.
1 = An event occurred on Mailbox x.
An event corresponds to MRDY, MABT fields in the CAN_MSRx register.
• ERRA: Error Active mode
0 = CAN controller is not in error active mode
1 = CAN controller is in error active mode
This flag is set depending on TEC and REC counter values. It is set when node is neither in error passive mode nor in bus
off mode.
This flag is automatically reset when above condition is not satisfied.
• WARN: Warning Limit
0 = CAN controller Warning Limit is not reached.
1 = CAN controller Warning Limit is reached.
This flag is set depending on TEC and REC counters values. It is set when at least one of the counters values exceeds 96.
This flag is automatically reset when above condition is not satisfied.
• ERRP: Error Passive mode
0 = CAN controller is not in error passive mode
1 = CAN controller is in error passive mode
This flag is set depending on TEC and REC counters values.
A node is error passive when TEC counter is greater or equal to 128 (decimal) or when the REC counter is greater or equal
to 128 (decimal) and less than 256.
This flag is automatically reset when above condition is not satisfied.
• BOFF: Bus Off mode
0 = CAN controller is not in bus-off mode
1 = CAN controller is in bus-off mode
This flag is set depending on TEC counter value. A node is bus off when TEC counter is greater or equal to 256 (decimal).
This flag is automatically reset when above condition is not satisfied.
• SLEEP: CAN controller in Low power Mode
0 = CAN controller is not in low power mode.
1 = CAN controller is in low power mode.
31 30 29 28 27 26 25 24
OVLSY TBSY RBSY BERR FERR AERR SERR CERR
23 22 21 20 19 18 17 16
TSTP TOVF WAKEUP SLEEP BOFF ERRP WARN ERRA
15 14 13 12 11 10 9 8
MB15 MB14 MB13 MB12 MB11 MB10 MB9 MB8
7 6 5 4 3 2 1 0
MB7 MB6 MB5 MB4 MB3 MB2 MB1 MB0