Rainbow Electronics AT91CAP9S250A - Manual (Page 981)

981
6264A–CAP–21-May-07
AT91CAP9S500A/AT91CAP9S250A
47.10.9 MCI Timings
The PDC interface block controls all data routing between the external data bus, internal
MMC/SD module data bus, and internal system FIFO access through a dedicated state machine
that monitors the status of FIFO content (empty or full), FIFO address, and byte/block counters
for the MMC/SD module (inner system) and the application (user programming).
Timings are given assuming a capacitance load on data and clock.
Figure 47-12. MCI Timings
Table 47-40. Capacitance Load on Data, Clock Pads
Corner
Supply Max STH Min
3.3V 25pf 25pf 25pf
1.8V 25pf 25pf 25pf
CLK
CMD_DAT Input
MCI1
CMD_DAT Output
MCI2 MCI3
MCI4 MCI5
Shaded areas are not valid
Table 47-41. MCI Timings @1.8V
Symbol Parameter 1.8V Min Max Unit
MCI
1
CLK frequency at Data transfer Mode
10 cards 25 MHz
30 cards 5 MHz
CLK frequency at Identification Mode 400 kHz
MCI
2
Input hold time TBD ns
MCI
3
Input setup time TBD ns
MCI
4
Output change after CLK rising TBD ns
MCI
5
Output valid before CLK rising TBD ns
Table 47-42. MCI Timings @3.3V
Symbol Parameter 3.3V Min Max Unit
MCI
1
CLK frequency at Data transfer Mode
10 cards 25 MHz
30 cards 5 MHz
CLK frequency at Identification Mode 400 kHz