Alpha Technologies XM2, XM2-HV, XM2-HP - Manual (Page 60)

5. Press ENTER when the desired value displays. This accesses an additional
display where you can either ESCAPE from programming mode and not save the
new value or press ENTER to accept and save the new value.
6. After the value is saved, the display returns to the Setup Menu. You may now
check and view the new value or select additional parameters to modify.
If an incorrect value is entered, repeat the above process and enter the proper value;
or select the Set Defaults menu selection on the Setup Menu and press ENTER twice
to reset all parameters to their factory default values.
In addition to using UP and DOWN to increase or decrease numerical values, you
can select ON or OFF and YES or NO in the same manner as described. The CODE
VER, XM_CLASS VER and Total Run Time selections are for informational display
only and cannot be edited. To return to the “Operation Normal” menu from the Setup
Menu, press ESCAPE three times.
4.3 Smart Display Modes, continued
4.3.3 Setup Menu
Pressing ENTER while in the Comms Status display opens the Setup Menu, one
level below the Comms Status display. Using the Setup menu you can view and
change the programmable operating parameters of the power supply or the optional
PIM. Setup Menu navigation is similar to the Operation Normal menu. Press UP
or DOWN to access the Single Step mode where sub-menu items are individually
selected.
To select and change a value in the Setup Menu:
1. Press either UP or DOWN to put the display in the Manual Scroll mode.
2. Continue to press UP or DOWN until the desired item is displayed.
3. Press ENTER to select the item for editing.
4. Use UP to increase the displayed value or DOWN to decrease the value. To
change the displayed value more rapidly, press and hold either UP or DOWN for
more than two seconds while in edit mode.
The Set Defaults menu selection does not reset Standby Time, Standby Events or Device Address;
you must manually reset these settings.
NOTE:
When in EDIT mode, press the ENTER key twice for the change in the parameter to take effect.
NOTE:
60 017-805-B0-010 Rev. K2