Micromod Micro-DCI: 53MC5000 Multi-Loop Process Controller CUSTOMIZATION GUIDE - Manual (Page 75)

F-CIM 73
AUTO/MANUAL SWITCH - 3
NOT REUSABLE
INPUTS NAME SYMBOL DATAPOINT
S n-1 CONTROL OUTPUT CO3 C231
A AUTO ENABLE AE3 L186
B OUTPUT TRACK VALVE OTV3 C237
C OUTPUT TRACK SWITCH SWOTV3 L189
PARAMETERS OUTPUT TRACK ENABLE OTE3 L191
HARD MANUAL LIMIT HML3 L194
OUTPUT HIGH LIMIT OH3 C217
OUTPUT LOW LIMIT OL3 C218
OUTPUT SLEW RATE T33 C226
OUTPUTS
S n OUTPUT OUT3 C210
OUTPUT TRACK STATUS OVTS3 L177
AUTO STATUS AUT3 L179
Description:
This module selects one of three signals to load into OUT and become its output
(S
n
). The signal selected is either the Output Tracking Value (B), the Auto Value
(S
n-1
) or the Manual Pushbutton Value. If the Output Tracking Switch (C) is less
than 1, then S
n
= B when Output Tracking is enabled (OTE = 1). When the pre-
vious condition is not in effect S
n
will equal S
n-1
if Auto Enable (A) is
≥ 1 and the
A/M pushbutton has set the Auto Switch to 1. When neither previous condition is
in effect the selected signal comes directly from the output increase and decrease
pushbuttons.
MODULAR CONTROLLER CUSTOMIZATION GUIDE
3-23