Teledyne 6200E - Sulfides Analyzer - Manual (Page 108)

Operating Instructions Model 6200E Instruction Manual
108 M6200E Rev: A1
Table 6-16: LAN/Internet Configuration Properties
PROPERTY DEFAULT STATE DESCRIPTION
DHCP
STATUS
On Editable
This displays whether the DHCP is
turned ON or OFF.
INSTRUMENT
IP ADDRESS
Configured
by DHCP
EDIT key
disabled
when DHCP
is ON
This string of four packets of 1 to
3 numbers each (e.g.
192.168.76.55.) is the address of
the analyzer itself.
GATEWAY IP
ADDRESS
Configured
by DHCP
EDIT key
disabled
when DHCP
is ON
A string of numbers very similar
to the Instrument IP address (e.g.
192.168.76.1.)that is the address
of the computer used by your LAN
to access the Internet.
SUBNET
MASK
Configured
by DHCP
EDIT key
disabled
when DHCP
is ON
Also a string of four packets of 1
to 3 numbers each (e.g.
255.255.252.0) that defines that
identifies the LAN the device is
connected to.
All addressable devices and
computers on a LAN must have
the same subnet mask. Any
transmissions sent devices with
different assumed to be outside of
the LAN and are routed through
gateway computer onto the
Internet.
TCP PORT 3000 Editable
This number defines the terminal
control port by which the
instrument is addressed by
terminal emulation software, such
as Internet or Teledyne Analytical
Instruments’ APICOM.
HOST NAME 101E Editable
The name by which your analyzer
will appear when addressed from
other computers on the LAN or
via the Internet. While the
default setting for all Teledyne
Analytical Instruments M6200E
analyzers is “M6200E” the host
name may be changed to fit
customer needs.
1 Do not change the setting for this property unless instructed to by Teledyne
Analytical Instruments Customer Service personnel.