Teledyne 6200E - Sulfides Analyzer - Manual (Page 153)

Model 6200E Instruction Manual Operating Instructions
M6200E Rev: A1 153
6.12.4.6. Hessen Protocol Gas ID
Since the M6200E can be, when the proper optional equipment is installed and operating, a
multigas instrument that measures both H
2
S and SO
2
, both of these gases are listed in the Hessen
protocol gas list. In its default state the Hessen protocol firmware assigns both gases a Hessen ID
number and actively reports both even if the instrument is only measuring one.
To change or edit these settings press:
KEY FUNCTION
<PREV Moves to next gas entry in list
NEXT> Moves the cursor previous gas entry in list
INS Inserts a new gas entry into the list.
DEL Deletes the >>>>>.
ENTR Accepts the new setting and returns to the previous menu.
EXIT Ignores the new setting and returns to the previous menu.
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE RANGE = 500.0 PPB H2S =XXX.X
< TST TST > CAL SETUP
SETUP X.X HESSEN RESPONSE MODE :CMD
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X.X HESSEN VARIATION: TYPE 1
SET> EDIT EXIT
SETUP X.X HESSEN GAS LIST
<SET SET> EDIT EXIT
ENTR key
accepts the new
settings
EXIT key ignores
the new settings
SETUP X.X SO2, 111, REPORTED
<PREV NEXT> INS DEL EDIT PRNT EXIT
SETUP X.X GAS TYPE SO2
<PREV NEXT> ENTR EXIT Use the PREV & NEXT keys to cycle
between the SO2 & H2S
SETUP X.X GAS ID: 111
0 0 0 ENTR EXIT
Use the PREV & NEXT keys to cycle
between the SO2 & H2S
SETUP X.X REPORTED : ON
ON ENTR EXIT
Toggle this key to switch reporting
Between ON and OFF
Use the PREV & NEXT keys to cycle
existing entries in Hessen gas list