Gentec-EO Beamage-3.0 - Manual (Page 8)

Beamage-3.0 User Manual Revision 6.0 7
1. BEAMAGE-3.0
1.1. INTRODUCTION
Gentec-EO introduces the new Beamage-3.0. Its sleek and thin design allows the Beamage-3.0 to fit
between tight optical components. Its USB 3.0 connection and improved algorithm allows very fast frame
rates. The new 2.2 MPixel CMOS sensor has a large
⅔” optical format with a small 5.5 µm pixel pitch
allowing high resolution on large beams. Most importantly the innovative and improved PC-Beamage-3.0
software is simple and intuitive to any new or expert beam profiling user.
1.2. SPECIFICATIONS
The following specifications are based on a one-year calibration cycle, an operating temperature of 18 to
28ºC (64 to 82ºF) and a relative humidity not exceeding 80%.
Table 1-1 List of Specifications
Sensor Specification
Sensor Technology CMOS without coverglass
Sensor Size 11.3 x 6.0 mm
Sensor Area 0.67 cm
2
Pixel Count 2.2 MPixels
Pixel H x V 2048 x 1088
Optical Format ⅔”
Pixel Dimension 5.5 µm
Minimum Measurable
Beam
55 µm
ADC 12 bit (default) or 10 bit
Shutter Type Global
Wavelength Range 350 -1150 nm
Frame Rate 8 fps (2.2 MPixel Full Frame)
15 fps (1.1 MPixel Active Area 2048 x544)
32 fps (0.066 MPixel Active Area 256 x 256)
RMS noise 1000:1 (60 dB)
Minimum and
Maximum Exposure
Times
0.06 to 100 ms
External Trig SMA connector
1.1 volts to 24 volts, the rise edge response time is 300 ns
Trigger signal pulse width: 300 ns to 230 ms
Optional SMA to BNC adaptor (202273) :