Gentec-EO Beamage-3.0 - Manual (Page 62)

Beamage-3.0 User Manual Revision 6.0 61
These measurements are on the XY Display. Use the Display VIs to choose the XY Display and the
Activate VIs to set the software before requesting measurement data from the software.

Measure X 1OVRE^2 and Measure Y 1OVRE^2

Measure X Centroid and Measure Y Centroid

Measure X FWHM and Measure Y FWHM

Measure X Gaussian Equation and Measure Y Gaussian Equation

Measure X Gaussian Fit % and Measure Y Gaussian Fit %

Measure X Peak to Average and Measure Y Peak to Average

Measure X Peak and Measure Y Peak

Measure X Roughness Fit and Measure Y Roughness Fit
These measurements are on the TRACK Display. Use the Display VIs to choose the TRACK Display
before requesting measurement data from the software.

Measure X Last and Measure Y Last

Measure X Mean and Measure Y Mean

Measure X Delta and Measure Y Delta

Measure Azimuth

Measure Delta

Measure Number of Samples

Measure RMS
7.1.4. Display VIs.
These VIs decide which display the PC-Beamage-3.0 software will use. Using them is the same as
pressing one of the four display buttons on the bottom of the software screen.

Display 2D. Switches to the 2 D display screen.

Display 3D. Switches to the 3 D display screen.

Display XY. Switches to the XY display screen.

Display TRACK. Switches to the Beam Track display screen.