Gentec-EO Beamage-3.0 - Manual (Page 47)

Beamage-3.0 User Manual Revision 6.0 46
Figure 5-13 Coordinates Defined by User
To set the origin back to its default position (0,0), click on the “Reset origin” button below “User define”.
This will also automatically select the default option “Centroid” for the origin position.
Once the origin position is determined by the user, the software will calculate the difference between the
coordinates of this new position and the latest computed centroid or peak coordinates. The results are
displayed in the
“Measures” section of the “Relative Position” tab.
Figure 5-14 Measures Section
It is possible to save the data in the Acquisition file. To do so, select the “Save this data in the Acquisition
file ” option at the bottom of the “Measures” section.