Gentec-EO Beamage-3.0 User Manual
Page 81
Beamage-3.0 User Manual Revision 6.0
80
ANNEX D RECYCLING AND SEPARATION PROCEDURE FOR WEEE
This section is used by the recycling center when the Beamage-3.0 reaches its end of line. Breaking the
calibration seal or opening the Beamage-3.0
’s case will void the warranty
The compete Beamage-3.0 contains:
1 Beamage-3.0
1 USB 3.0 cable with screw locks
1 BNC to SMA connector
1 Software CD-ROM
1. Separation
Plastic: Aperture cap, SMA cap.
Metal: Beamage-3.0
’s case, screws, SMA connector, BNC to SMA connector, ND filter holder.
Wires: USB cable.
Printed circuit board: inside the Beamage-3.0.
Glass: ND filter.
CD: CD-ROM.
2. Dismantling procedure
Remove the 3 screws on the BEAMAGE’s back cover with an Allen key.
Remove the 1 screw holding the PCB’s with a flat screw driver.
Cut the wire between the PCB and the SMA connector.
Remove the ND filter and remove the glass with a spanner wrench.