Gentec-EO Beamage-3.0 - Manual (Page 50)

Beamage-3.0 User Manual Revision 6.0 49
Figure 5-19 Fixed Crosshair Section
By selecting “Centroid” and clicking “Set now”, the user chooses to position the origin of the crosshairs at
the calculated centroid position
(center of energy). By selecting “Peak” and clicking “Set now”, the user
chooses to position the origin of the crosshairs at the calculated peak energy position (highest measured
value). The option “User define”, allows the user to manually enter the origin of the crosshairs at a defined
position in both the X and Y axes.
Figure 5-20 User-Defined Origin
Once the origin of the crosshairs is determined by the user, the software will be able to see the crosshairs
from this particular origin.