Gentec-EO Beamage-3.0 User Manual
Page 80
Beamage-3.0 User Manual Revision 6.0
79
ANNEX C BEAMAGE-3.0 FIRMWARE INSTALLATION QUICK GUIDE
1) If the software version of the PC-Beamage-3.0 is not compatible with the Beamage-
3.0’s firmware
version, an error message will appear. If so, it is important to update the firmware version
and to reinstall the drivers in order to use the PC-Beamage-
3.0’s new functions.
2) First, download the latest BeamageUpdater available on Gentec-EO
’s website
3) Connect the Beamage-3.0 to your computer. If the Beamage-3.0 is already connected, please
disconnect and reconnect it.
4) Run the CameraUpdater.
5)
Click on “Update”.
Figure C-1
6) The Beamage-3.0 Updater might ask you to reset the Beamage-3.0. If so, please disconnect and
reconnect the Beamage-
3.0 and click on “Update” again.
7) Once this is done, a message box will appear. Click on OK.
Figure C-2
8) Once the Bemage-
3.0’s firmware is up to date, update the drivers by following the steps
described in Annex B. Please note that even if the drivers were previously installed, the new
software and firmware versions need a new driver installation.