Gentec-EO Beamage-3.0 - Manual (Page 61)

Beamage-3.0 User Manual Revision 6.0 60

Control 1OVRe^2.
This VI sets the Beam Diameter Definition Control in the PC-Beamage-3.0 Software. Running this VI is
the same as pressing the selecting the 1/e
2
along crosshairs (13.5%) control in the software.

Control 86%.
This VI sets the Beam Diameter Definition Control in the PC-Beamage-3.0 Software. Running this VI is
the same as pressing the selecting the 86% effective diameter (D86) control in the software.

Control Centroid.
This VI sets the Crosshair Center Control in the PC-Beamage-3.0 Software. Running this VI is the same
as pressing the selecting the Centroid control in the software.

Control Peak.
This VI sets the Crosshair Center Control in the PC-Beamage-3.0 Software. Running this VI is the same
as pressing the selecting the Peak control in the software.

Control Auto.
This VI sets the Crosshair Orientation Control in the PC-Beamage-3.0 Software. Running this VI is the
same as pressing the selecting the Auto Orient control in the software.

Control Zero.
This VI sets the Crosshair Orientation Control in the PC-Beamage-3.0 Software. Running this VI is the
same as pressing the selecting the 0 degrees control in the software.

Control 45.
This VI sets the Crosshair Orientation Control in the PC-Beamage-3.0 Software. Running this VI is the
same as pressing the selecting the 45 degrees control in the software.
7.1.3. Measurement VIs
The measurement VIs for the Diameter and Position. Position VIs have separate VIs for the X and Y
measurements. Running the selected VI returns the reading from the software.
7.1.3.1. Diameter VIs.

Measure Effective Diameter

Measure Effective Diameter

Measure Ellipticity

Measure Orientation

Measure Peak Saturation

Measure Major Axis

Measure Minor Axis
7.1.3.2. Position VIs.