Gentec-EO Beamage-3.0 - Manual (Page 16)

Beamage-3.0 User Manual Revision 6.0 15
4. THE MAIN CONTROLS
Figure 4-1 PC-Beamage-3.0 Main Controls
To give more room to the graphical display and less to the ribbon, you can minimize the ribbon by right
clicking on
it and choosing “Minimize the ribbon”. You can retrieve the ribbon at any time by right clicking
on the upper portion of the window and unchecking “Minimize the ribbon”.
Figure 4-2 The PC-Beamage-3.0 Interface With and Without the Main Controls Ribbon
4.1. MULTIPLE BEAMAGE-3.0 MODE
It is possible to connect multiple Beamage-3.0 to a single computer. When you start the PC-Beamage-3.0
the following window showing all the serial numbers of the connected cameras will appear. If numerous
Beamage-3.0 are connected to the computer, please select the desired camera. To connect to another
Beamage-3.0 simultaneously, you must first start all desired PC-Beamage-3.0 instances one by one
before selecting the desired serial number for each instance. For example, if you have 2 cameras, first
open an instance of PC-Beamage-3.0 and wait for the Beamage-3.0 Selector dialog. Then, open another
instance of PC-Beamage-3.0 and wait for the Bemage-3.0 Selector dialog. Then, go back to the first
instance and select the appropriate serial number. Then, go back to the second instance and do the
same. You can start streaming after all the desired Beamage-3.0 have been connected to a PC-
Beamage-3.0 instance.