Gentec-EO Beamage-3.0 User Manual
Page 77
Advertising
Beamage-3.0 User Manual Revision 6.0
76
14) Start the PC-Beamage-3.0 application. A camera selector will appear, with a series of zero as the
single option. Meanwhile, the last driver will be installed. Wait for the following message to appear
at the bottom right of your screen. Click on OK in and close the application.
Figure B- 14: Driver installed successfully (2)
Figure B- 15: Camera Selector (1)
15) Restart the PC-Beamage-3.0 application. Select your camera and click on OK. The 6 digits
following the dash correspond to the serial number of your device. You are now ready to use your
Beamage-3.0.
Figure B- 16: Camera Selector (2)
Advertising