Gentec-EO Beamage-3.0 User Manual
Page 78
Beamage-3.0 User Manual Revision 6.0
77
Verify that the driver has been correctly installed
It is not necessary to follow these steps to install the USB drivers. They are verification steps only.
1) Open your Device Manager. To open the Device Manager, click on the Start (Windows home
screen) and type in Device Manager in the search field. Click on Device Manager under Control
Panel. Be careful not to click on Devices and Printers instead of Device Manager.
Figure B- 17:
Search for “Device Manager”
You can also open the Device Manager through the System Window
2) Close the PC-Beamage-3.0 application (if it is already opened). Connect the Beamage-3.0
camera to your computer. If everything went well until now, the device Cypress USB BootLoader
should be marked by a yellow warning in the Device Manager. It should be located under
Universal Serial Bus controllers.
Figure B- 18: Cypress USB BootLoader