Asante Technologies 40240/40480-10G - Manual (Page 132)

* These are legacy notifications and therefore must be enabled in conjunction with the corresponding traps on the
SNMP Configuration menu (page 5-6).
5-15
Configuring SNMPv3 Management Access
Table 5-2 Supported Notification Messages (Continued)
5
Object Label
Private Traps -
swPowerStatus
ChangeTrap
swFanFailureTrap
swFanRecoverTrap
swIpFilterRejectTrap
swSmtpConnFailure
Trap
swMainBoardVer
MismatchNotificaiton
swModuleVer
MismatchNotificaiton
swThermalRising
Notification
swThermalFalling
Notification
swModuleInsertion
Notificaiton
swModuleRemoval
Notificaiton
Object ID Description
1.3.6.1.4.1.202.20.57.84.2.1.0.1 This trap is sent when the power state changes.
1.3.6.1.4.1.202.20.57.84.2.1.0.17 This trap is sent when the fan fails.
1.3.6.1.4.1.202.20.57.84.2.1.0.18 This trap is sent when the fan failure has
recovered.
1.3.6.1.4.1.202.20.57.84.2.1.0.40 This trap is sent when an incorrect IP address is
rejected by the IP Filter.
1.3.6.1.4.1.202.20.57.84.2.1.0.41 This trap is triggered if the SMTP system cannot
open a connection to the mail server
successfully.
1.3.6.1.4.1.202.20.57.84.2.1.0.56 This trap is sent when the slave board version is
mismatched with the master board version. This
trap binds two objects, the first object indicates
the master version, whereas the second
represents the slave version.
1.3.6.1.4.1.202.20.57.84.2.1.0.57 This trap is sent when the slide-in module
version is mismatched with the main board
version.
1.3.6.1.4.1.202.20.57.84.2.1.0.58 This trap is sent when the temperature exceeds
the switchThermalActionRisingThreshold.
1.3.6.1.4.1.202.20.57.84.2.1.0.59 This trap is sent when the temperature falls below
the switchThermalActionFallingThreshold.
1.3.6.1.4.1.202.20.57.84.2.1.0.60 This trap is sent when a module is inserted.
1.3.6.1.4.1.202.20.57.84.2.1.0.61 This trap is sent when a module is removed.