Asante Technologies 40240/40480-10G - Manual (Page 659)

* These commands are used for manua ly binding an address to a client.
service dhcp
This command enables the DHCP server on this switch. Use the no form to disable
the DHCP server.
Syntax
[no] service dhcp
Default Setting
Enabled
Command Mode
Global Configuration
39-5
DHCP Server
DHCP Server
Table 39-4 DHCP Server Commands
Function
Enables the DHCP server feature on this switch
Specifies IP addresses that a DHCP server should not assign to
DHCP clients
Configures a DHCP address pool on a DHCP Server
Configures the subnet number and mask for a DHCP address
pool
Specifies the default router list for a DHCP client
Specifies the domain name for a DHCP client
Specifies the Domain Name Server (DNS) servers available to a
DHCP client
Configures the next server in the boot process of a DHCP client
Specifies a default boot image for a DHCP client
Configures NetBIOS Windows Internet Naming Service (WINS)
name servers available to Microsoft DHCP clients
Configures NetBIOS node type for Microsoft DHCP clients
Sets the duration an IP address is assigned to a DHCP client
Specifies the IP address and network mask to manually bind to a
DHCP client
Specifies a client identifier for a DHCP client
Specifies the hardware address of a DHCP client
Deletes an automatic address binding from the DHCP server
database
Command
service dhcp
ip dhcp
excluded-address
ip dhcp pool
network
default-router
domain-name
dns-server
next-server
bootfile
netbios-name-server
netbios-node-type
lease
host *
client-identifier *
hardware-address *
clear ip dhcp binding
show ip dhcp binding
Mode Page
GC 39-5
GC 39-6
GC 39-6
DC 39-7
DC 39-8
DC 39-8
DC 39-9
DC 39-9
DC 39-10
DC 39-10
DC 39-11
DC 39-11
DC
DC
DC
PE
39-12
39-13
39-14
39-14
39-15 Displays address bindings on the DHCP server PE,
NE
39