Displaying interface settings for mstp, Figure 10-8, Mstp port information – Asante Technologies 40240/40480-10G User Manual

Page 225: Configuring interface settings for mstp, Spanning tree algorithm

Advertising
background image

.

Configuring Interface Settings for MSTP

You can configure the STA interface settings for an MST Instance using the MSTP
Port Configuration and MSTP Trunk Configuration pages.

Field Attributes

The following attributes are read-only and cannot be changed:

STA State – Displays current state of this port within the Spanning Tree.

(See Displaying Interface Settings on page 10-10 for additional information.)

Discarding - Port receives STA configuration messages, but does not forward

packets.

Learning - Port has transmitted configuration messages for an interval set by

the Forward Delay parameter without receiving contradictory information. Port
address table is cleared, and the port begins learning addresses.

Forwarding - Port forwards packets, and continues learning addresses.

Trunk – Indicates if a port is a member of a trunk.

(STA Port Configuration only)

The following interface attributes can be configured:

MST Instance ID – Instance identifier to configure. (Range: 0-4094; Default: 0)

Priority – Defines the priority used for this port in the Spanning Tree Protocol. If

the path cost for all ports on a switch are the same, the port with the highest priority
(i.e., lowest value) will be configured as an active link in the Spanning Tree. This
makes a port with higher priority less likely to be blocked if the Spanning Tree

10-20

---------------------------------------------------------------

Eth 1/

1

information

---------------------------------------------------------------

Admin Status:

Enabled

Role: designate

State: forwarding

External Admin Path Cost: 0

Internal Admin Path Cost: 0

External Oper Path Cost:

Internal Oper Path Cost:

Priority:

Designated Cost:

Designated Port:

Designated Root:

Designated Bridge:

Fast Forwarding:

Forward Transitions:

Admin Edge Port:

Oper Edge Port:

Admin Link Type:

Oper Link Type:

.

Spanning Tree Status:

10000

10000

128

0

128.23

32768.0.0000E8900000

32768.0.0000E8900000

Disabled

4

Disabled

Disabled

auto

Point-to-point

Enabled

Spanning Tree Algorithm

10

.

Advertising