Asante Technologies 40240/40480-10G - Manual (Page 408)

show startup-config
This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in
non-volatile memory.
• This command displays settings for key command modes. Each mode group
is separated by “!” symbols, and includes the configuration mode command,
and corresponding commands. This command displays the following
information:
- MAC address for each switch in the stack
- SNTP server settings
- SNMP community strings
- Users (names and access levels)
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- Multiple spanning tree instances (name and interfaces)
- IP address configured for VLANs
- Layer 4 precedence settings
- Routing protocol configuration settings
- Spanning tree settings
- Any configured settings for the console port and Telnet
23-3
Command Function
show startup-config Displays the contents of the configuration file (stored in flash
memory) that is used to start up the system
show running-config Displays the configuration data currently in use
show system Displays system information
show users Shows a l active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
show version Displays version information for the system
Mode
PE
PE 23-5
NE, PE 23-7
NE, PE 23-8
NE, PE 23-8
System Status Commands
System Status Commands
This section describes commands used to display system information.
Table 23-3 System Status Commands
23
Page
23-3