Asante Technologies 40240/40480-10G - Manual (Page 647)

ip host
This command creates a static entry in the DNS table that maps a host name to an
IP address. Use the no form to remove an entry.
Syntax
[no] ip host name address1 [address2 … address8]
• name - Name of the host. (Range: 1-127 characters)
• address1 - Corresponding IP address.
• address2 … address8 - Additional corresponding IP addresses.
Default Setting
No static entries
Command Mode
Global Configuration
38-1
Chapter 38: Domain Name Service Commands
These commands are used to configure Domain Naming System (DNS) services.
Entries can be manually configured in the DNS domain name to IP address mapping
table, default domain names configured, or one or more name servers specified to
use for domain name to address translation.
Note that domain name services will not be enabled until at least one name server is
specified with the ip name-server command and domain lookup is enabled with the
ip domain-lookup command.
Table 38-1 DNS Commands
Command Function
ip host Creates a static host name-to-address mapping
clear host Deletes entries from the host name-to-address table
ip domain-name Defines a default domain name for incomplete host names
ip domain-list Defines a list of default domain names for incomplete host names
ip name-server Specifies the address of one or more name servers to use for host
name-to-address translation
ip domain-lookup Enables DNS-based host name-to-address translation
show hosts Displays the static host name-to-address mapping table
show dns Displays the configuration for DNS services
show dns cache Displays entries in the DNS cache
clear dns cache Clears all entries from the DNS cache
Mode Page
GC 38-1
PE 38-2
GC 38-3
GC 38-3
GC 38-4
GC 38-5
PE 38-6
PE 38-7
PE 38-7
PE 38-8