Asante Technologies 40240/40480-10G - Manual (Page 655)

ip dhcp client-identifier
This command specifies the DCHP client identifier for the current interface. Use the
no form to remove this identifier.
Syntax
ip dhcp client-identifier {text text | hex hex}
no ip dhcp client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
Interface Configuration (VLAN)
39-1
Chapter 39: DHCP Commands
These commands are used to configure Dynamic Host Configuration Protocol
(DHCP) client, relay, and server functions. You can configure any VLAN interface to
be automatically assigned an IP address via DHCP. This switch can be configured to
relay DHCP client configuration requests to a DHCP server on another network, or
you can configure this switch to provide DHCP service directly to any client.
Table 39-1 DHCP Commands
Command Group Function
DHCP Client Allows interfaces to dynamically acquire IP address information
DHCP Relay Relays DHCP requests from local hosts to a remote DHCP server
DHCP Server Configures DHCP service using address pools or static bindings
DHCP Client
Use the commands in this section to allow the switch’s VLAN interfaces to
dynamically acquire IP address information.
Table 39-2 DHCP Client Commands
Page
39-1
39-3
39-5
Command
ip dhcp client-identifier
ip dhcp restart client
Function Mode Page
Specifies the DHCP client identifier for this switch IC 39-1
Submits a BOOTP or DHCP client request PE 39-2