Asante Technologies 40240/40480-10G - Manual (Page 645)

ip igmp snooping vlan mrouter
This command statically configures a multicast router port on the specified VLAN.
Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not always be
able to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on your router, you can manually configure that interface to join all the
current multicast groups.
Example
The following shows how to configure port 11 as a multicast router port within VLAN 1:
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#
37-9
Static Multicast Routing Commands
This section describes commands used to configure static multicast interfaces on
the switch.
Table 37-4 Static Multicast Routing Commands
Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter
Function Mode Page
Adds a multicast router port GC 37-9
Shows multicast router ports PE 37-10
Static Multicast Routing Commands
37