Asante Technologies 40240/40480-10G - Manual (Page 555)

objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
• This attribute must comply with the following rule:
(4 * tx-delay)
″ refresh-interval
Example
Console(config)#lldp tx-delay 10
Console(config)#
lldp admin-status
This command enables LLDP transmit, receive, or transmit and receive mode on the
specified port. Use the no form to disable this feature.
Syntax
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
• rx-only - Only receive LLDP PDUs.
• tx-only - Only transmit LLDP PDUs.
• tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#
lldp notification
This command enables the transmission of SNMP trap notifications about LLDP
changes. Use the no form to disable LLDP notifications.
Syntax
[no] lldp notification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
32-6
LLDP Commands
32