Asante Technologies 40240/40480-10G - Manual (Page 594)

interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
34-7
Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN
is activated by default.
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Related Commands
show vlan (34-13)
Configuring VLAN Interfaces
Table 34-4 Commands for Configuring VLAN Interfaces
Command
interface vlan
switchport mode
switchport
acceptable-frame-types
switchport ingress-filtering
switchport native vlan
switchport allowed vlan
switchport gvrp
switchport forbidden vlan
switchport priority default
Function Mode Page
Enters interface configuration mode for a specified VLAN IC 34-7
Configures VLAN membership mode for an interface IC 34-8
Configures frame types to be accepted by an interface IC 34-9
Enables ingress filtering on an interface IC 34-9
Configures the PVID (native VLAN) of an interface IC 34-10
Configures the VLANs associated with an interface
Enables GVRP for an interface
Configures forbidden VLANs for an interface
Sets a port priority for incoming untagged frames
IC 34-11
IC 34-3
IC 34-12
IC 35-3
Configuring VLAN Interfaces
34