Asante Technologies 40240/40480-10G - Manual (Page 588)

Chapter 34: VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Table 34-1 VLAN Commands
Command Groups
GVRP and Bridge Extension
Editing VLAN Groups
Configuring VLAN
Interfaces
Displaying VLAN
Information
Configuring 802.1Q
Tunneling
Configuring Private VLANs
Configuring Protocol VLANs
Function
Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
Sets up VLAN groups, including name, VID and state
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
Displays VLAN groups, status, port members, and MAC addresses
Configures 802.1Q Tunneling (QinQ Tunneling)
Configures private VLANs, including uplink and downlink ports
Configures protocol-based VLANs based on frame type and protocol
Page
34-1
34-5
34-7
34-12
34-14
34-18
34-20
GVRP and Bridge Extension Commands
GARP VLAN Registration Protocol defines a way for switches to exchange VLAN
information in order to automatically register VLAN members on interfaces across
the network. This section describes how to enable GVRP for individual interfaces
and globally for the switch, as well as how to display default configuration settings
for the Bridge Extension MIB.
Table 34-2 GVRP and Bridge Extension Commands
Command Function
bridge-ext gvrp Enables GVRP globally for the switch
show bridge-ext Shows the global bridge extension configuration
switchport gvrp Enables GVRP for an interface
switchport forbidden vlan Configures forbidden VLANs for an interface
show gvrp configuration Displays GVRP configuration for the selected interface
garp timer Sets the GARP timer for the selected function
show garp timer Shows the GARP timer for the selected function
Mode Page
GC 34-2
PE 34-2
IC 34-3
IC 34-12
NE, PE 34-3
IC 34-4
NE, PE 34-5
34-1