Asante Technologies 40240/40480-10G - Manual (Page 421)

boot system
This command specifies the file or image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of configuration file or code image.
• unit* - Stack unit. (Range: 1-8)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir (23-14)
whichboot (23-15)
23-16
System Management Commands
23