Asante Technologies 40240/40480-10G - Manual (Page 705)

clear ipv6 traffic
This command resets IPv6 traffic counters.
Command Mode
Privileged Exec
Command Usage
This command resets all of the counters displayed by the show ipv6 traffic
command.
Example
Console#clear ipv6 traffic
Console#
ping ipv6
This command sends ICMP echo request packets to an IPv6 node on the network.
ping ipv6 address {ipv6-address | host-name} [size datagram-size |
repeat repeat-count | data hex-data-pattern | source source-address |
timeout seconds | verbose]
• ipv6-address - The IPv6 address of the device to ping. The address must
be formatted according to RFC 2373 “IPv6 Addressing Architecture,” using
8 colon-separated 16-bit hexadecimal values. One double colon may be
used in the address to indicate the appropriate number of zeros required to
fill the undefined fields.
• host-name - The name the IPv6 device to ping. A host name can be
resolved into an IPv6 address using DNS.
• datagram-size - Specifies the size of the datagram to send in each ping.
(Range: 48 - 18024 bytes)
• repeat-count - The number of pings to send. (Range: 1 - 2147483647)
• hex-data-pattern - The data pattern to send. (Range: 0 - FFFF)
• source-address - The source address or name to include in the ping. This
is normally set to an address assigned to the interface sending the ping.
• seconds - The timeout interval. (Range: 0 to 3600 seconds)
• verbose - Displays detailed output.
Default Setting
repeat - 5
timeout - 2 seconds
Command Mode
Normal Exec - The only command options are count and size.
Privileged Exec - All command options are available.
41-25
Basic IP Configuration
41